Designer Diamond, Designer Diamond Deluxe, Designer Diamond Royale
- Husqvarna Viking Designer Diamond
- Husqvarna Viking Designer Diamond Deluxe
- Husqvarna Viking Designer Diamond Royale
Directions for use
- ESD
- Service tools
- Settings
- Settings - Quick reference
- Belt tension -drive belt
- Belt tension -motor belt
- The play of the hook gear
- Setting the hook in relation to the feeding eccentric (After feeding)
- The gap between the needle and the hook
- Setting the needle plate (the hook cover) in relation to the needle in the feeding direction.
- Setting the feed unit sideways
- The height of the hook
- Feed dog height
- Setting the needle in center position
- The needle bar height
- The timing of the hook in relation to the needle
- Needle threader stop
- Threading device
- Presser foot parallelism to the feed dog
- Presser foot height to the needle plate
- Measure height (TP)
- Pivot height
- Stitch length balance basic setting
- Stitch length balance
- Side motion balance
- Lower thread tension (thread tension of the bobbin case)
- Upper thread tension - Hi Tension
- Upper thread tension - Extra Hi Tension
- Upper thread tension - Position Lo tension
- Upper thread tension - Position Cut Tension
- Setting the thread take-up spring
- Pre-setting of the step motor for the feed dog lowering
- Setting the feed dog in relation to the needle plate
- Feed Dog Lowering
- Disconnection when winding the bobbin
- Service program
- Motors
- Sensors
- service menu - Electronics
- Calibration of the touch screen
- Hi Tension
- Lo Tension
- "Emb Unit"
- "Balance"
- Front Lid
- Rear cover
- Front cover
- Remove Thread tension cover
- Consol, display holder
- Bobbin winding motor
- Bobbin winding sensor
- LCD screen
- Internal parts of front cover - Touch screen
- Internal parts of front cover - Check spring unit
- Internal parts of front cover - Reverse button
- Internal parts of front cover - Keyboard
- Base Plate
- Power supply
- Circuit board - Circuit diagram .
- Tension unit
- Tension unit - Replacement of the tension discs
- Tension unit - Replacement of the Step motor
- Sewing head
- Step motor of the needle
- Step motor of the Presser bar
- Presser bar bushing
- Needle bar bushing
- Sewing head re-building
- Arm shaft
- Hook cover complete
- Replace thread cutter knife
- Hook complete
- Feeding unit step motor
- Feeding unit
- The side feeding mechanism complete
- Lower Shaft
- Thread cutting unit
- EMBROIDERY UNIT
- Cover Y-slide
- Step motor cover
- Upper covers
- Lower cover
- Belt tension, Embroidery unit - Y-unit
- Step motor, Embroidery unit - X-unit
- Hoop holder Embroidery unit - Y-unit
- Fault finding diagram Designer Diamond
Comments (2)