Janome Memory Craft 11000
Changing External Parts
- Face and top covers
- Belt cover
- Bed cover
- Base
- Front cover
- Rear cover
- Thread tension unit
- Thread cutter unit
- Needle threader motor
- Wiring Diagram
Replacing
- Printed Circuit Board A
- Printed Circuit Boards F1, F2 and Slide volume
- Printed Circuit Board B
- Switching Power Supply
- DC Motor and Adjusting Motor Belt Tension
Adjusting
- Needle Drop Position
- Hook Timing
- Needle bar height
- Clearance between Needle and Hook
- Backlash between Hook Drive Gear and Lower Shaft Gear
- Presser Foot Position and Height
- Feed dog height
- Height of Embroidery Foot P
- Shield Plate Position
- Tension Release Mechanism
- Needle Thread Tension
- Replacing and Adjusting Threader plate
- Adjusting Needle Threader Switch
- TTP Adjusting Mode
Adjusting
- Stretch Stitch Balance
- Presser Foot Lifter Sensor
- Buttonhole Lever
- Presser Foot Sensor
- Remaining Bobbin Thread Sensor
- Thread Cutter Solenoid
- Upper Shaft Clutch Solenoid
- Thread Cutter Switch
- Bobbin Winder Stopper
- Threader Drawing Lever
- X and Y Sensors
- Sewing Start Position
- Setting Position of Thread Take Up lever
Comments